Installing and Setting Up Teamspeak

Posted on

Skype, Yahoo Messenger, GoogleTalk and Live Messenger, all these have a lot of useless stuff you will not need when the only thing you want to do is have a voice conference with 5-10 or more people. Teamspeak is a dehydrated version of all these messengers leaving only voice conferencing which is solely what you need when multi-tasking. This is most useful when in online games. So to all •Barons• members or anyone who is a member of guild that does sieges out there, this is how to do it. c(”,)

logo_left.jpg

Teamspeak Installation:

1.) Download the file named TeamSpeak 2 Client here. The file is about 5mb in size.

2.) Install the program, it is very easy, just click next until the program is installed.

3.) Done!

Teamspeak Test:

1.) Make sure your headset and microphone are properly connected to the rear of you computer, the green jack(speakers/headphones) should be plugged in the green socket and the pink jack(microphone) should be plugged in the pink socket.

2.) Open Teamspeak and click "Settings" and then click "Sound Input/Output Settings". You should see this window below:

screenie.gif

There are two settings here:

a.) The first one is just a Volume slider that increases or decreases the speaker volume, I did not highlight this in the image.

b.) The second one, Voice Send Method has two options, "Push to Talk" and "Voice Activation". Push to talk means that to be able to send your voice message you need to press a key in the keyboard, this key can be assigned using the Set button and reset by the Clear button. Voice Activation on the other hand does not need a keypress but rather the sound and volume of your voice, there is a slider below this that sets how easily the system will detect the volume of your voice. Whisper detects the faintest of sounds, this is not recommended when you are using a speaker because it will cause a lot of feedback. Move the slider to the right until you get the mix just right. Don’t put it in Shout though because you will really need to yell just for the system to detect your voice.

3.) The last thing to do would be to will be to test the setup, in the Local Test section, click "Activate local test mode". This will allow you to test your microphone. Try speaking into the microphone, if the setup was a success you should hear your voice from the speakers. The Test Codec option specifies the sound quality, the higher the Kbit the better the sound will be.

Troubleshooting:

I have not encountered a lot of problems with installing or using Teamspeak so far but these by far are the most common:

1.) Cannot use the microphone will using the front panel jacks of the computer. The best solution I have for this would be to disable the front panel detection. This commonly applies to Realtek sound boards. To do this:

a.) Open the control panel for the Realtek sound card and look for the Audio IO window. Click the Connector Settings button:

realtek1.gif

b.) In the Connector Settings window make sure "Disable front panel jack detection" is checked.

realtek2.gif